Skip to product information

Injector Dynamics

ID1300x Fuel Injectors with Top Feed Fuel Rails Set of 4

Fits: 04-06 WRX STI

Profile Avatar

Talk to an Enthusiast

Verify Fitment & Product Recommendations

M-F 9:00AM - 6:00PM

Low stock! Only 3 left

Pay over time available · Est. $39.34/payment
ⓘ

Illustrative estimate only, not a financing quote or guaranteed offer. Actual payments, frequency and terms vary by provider and eligibility. Taxes, shipping and add-ons are excluded.

Pay over time available · Est. $39.34/payment
ⓘ

Illustrative estimate only, not a financing quote or guaranteed offer. Actual payments, frequency and terms vary by provider and eligibility. Taxes, shipping and add-ons are excluded.

Injector Dynamics ID1300x Fuel Injectors with Top Feed Fuel Rails Set of 4
Fits: 04-06 WRX STI
Be the first one to review

Fitment

Please Note: Part number: 1300.18.01.48.14.4 Top-feed conversion kit: set of 4 ID1300x injectors with dual billet fuel rails; converts the side-feed 2004-2006 WRX STI to top feed Also fits the 2005-2006 Legacy GT (same side-feed conversion application) Does not work with the stock fuel lines; the Injector Dynamics side feed conversion line kit is required when using the stock lines
  • 2004-2007 Subaru | WRX STI

Description

The ID1300x was designed with Bosch Motorsport specifically for alternative-fuel performance builds. It is the only performance injector with all stainless internals, so it stands up to the corrosive nature of alcohol fuels better than any other injector in the lineup, while its minimum fuel mass stays low enough for clean idle and cruise behavior when the car is run on gasoline. This top-feed conversion kit pairs the four-injector set with dual billet fuel rails to convert the side-feed 2004-2006 WRX STI to a top-feed setup without converting the TGVs or sourcing other parts.

  • Part number: 1300.18.01.48.14.4
  • Top-feed conversion kit with dual billet fuel rails
  • Set of 4 ID1300x injectors
  • Nominal flow rate: 1340 cc/min at 3.0 bar (43.5 psi) using Iso Octane at 52 degrees C
  • Maximum differential fuel pressure: 6.0 bar (87 psi)
  • Compatible with all known fuels; all stainless internals, designed specifically for alternative fuels
  • Electrical connector: USCAR
  • Full dynamic characterization data is supplied for ECU calibration
  • Fuel rails have -6 AN fittings on each end
  • Does not work with the stock fuel lines; the Injector Dynamics side feed conversion line kit is required when using the stock lines

Shipping and Delivery

Review our Shipping Policy for delivery details, shipping costs and exclusions.

Warranty and Support

For Injector Dynamics warranty information, contact our support team.

Return and Refund

Eligibility, exclusions, applicable fees and exceptions are detailed in our Return Policy. Restrictions apply to special-order and custom products.

Proposition 65

Proposition 65 Warnings: cancer and reproductive harm www.p65warnings.ca.gov